FAG magnetski indukcijski grijači all have a positive demagnetization function

FAG magnetski indukcijski grijači all have a positive demagnetization function

It is the application of metal to cause vortices in alternating electromagnetic fields, causing it to become hot. It is generally used in metal heat treatment processes and other aspects. The basic principle is that when a thicker metal is exposed to alternating electromagnetic fields, it will cause current due to the magnetic effect of the current. After the thicker metal causes an electric current, the current will form a spiral shaped themed activity surface inside the metal. In this way, the heat generated by the current themed activity will be digested and absorbed by the metal itself, causing the metal to quickly warm up. This machine is an environmentally friendly and energy-saving equipment that pre heats or re heats light fuel oil. Before incineration, the equipment heats up the light fuel oil to reduce its viscosity at high temperatures (105 degree -150 degree ), promoting sufficient atomization and incineration treatment, and achieving the purpose of resource conservation. It is widely used in places where light fuel oils such as fuel oil, drain oil, and vegetable oil are pre heated or reheated.

1. The electric heating components agree to operate under the following standards

2. The Humidity of the gas air does not exceed 95%, and there is no inženjering explosive or corosive para. (Eksplozija proof electric grijač vanjski)

3. The working voltage should not exceed 1.1 times the added value, and the casing should be equipped with a grounding device.

4. Uzemljenje otpor Greater than or equal to 1M Ω, volume resistivity: 2KV/1min

5. The grijanje cijev treba biti točno pozicionirano i fiksno mjesto, i the učinkovito grijanje područje must prodrijeti the tekuća or čvrsto metal as očekivano. Prazno gorjenje je je strogo zabranjeno. Kada prljavština or ugljik naslage are pronađene on the površina the the pipe, they treba be odmah uklonjeno i očišćeno prije use to prevent afektivno toplina disip and reducing the service life of the application.

6. When Heat fusible metals or solid nitrates, alkalis, drains, parafin, etc., the application voltage should be lowered first, and the additional voltage can only be raised after the material is melted.

7. When grijanje plin, the components should be placed in a cross and simetrično manner to ensure good heat discharge standards and sufficient grijanje of the air pass through the water grijač.

8. Kada grijanje nitrat, sigurnost mjere opreza treba biti preuzeto u razmatranje to prevent inženjering miniranje nesreće.

9. A part of the ožičenje treba biti placed outside the insulation layer to prevent contact with s korozija, inženjering explosive tvari, i vlaga; The olovo žica treba be able to withstand a porcija the temperatura and grijanje opterećenje of the žica za a dugo vrijeme, i te žica vijci treba be stegnuto to prevent prevent force.

10. Komponente treba biti pohranjeno in a suho i nezanimljivo mjesto. If the grounding resistance is manje than 1M Ω due to long-term placement, they can be dried in a drying oven at or above 200 degree , or the voltage can be reducirano i plugged in za grijanje until rehabilitation treatment of the grounding resistance.

11. The magnezij oksid prah at the outlet of the grijanje cijev grupa je korišteno in primjena site to prevent air onečišćujuće tvari i voda od ulazak, i to prevent the occurrence of electric accidents.

Www.superbheater.com